Optical Monitoring provides the highest accuracy needed for today's precision thin film coatings. Crystal monitors, by design, only measure the mass of a coating layer and cannot detect changes in the layer density caused by a variations in one of the many process variables. If not caught, a change in layer density results in a variation of the optical thickness which can lead to dramatic performance reductions and possible lost runs and revenue.

Optical monitors, on the other hand, provide continuous real-time monitoring of the optical performance of each layer by measuring the reflectance or transmission of the coating throughout the coating run. This measurement is compared against a well known relationship for the optical thickness of each layer so that precise termination of each layer can be achieved.

Figure 1.0 below shows a typical plot of monitor chip reflectance vs. thickness generated by a coating design software package. The layer termination points noted by the solid vertical bars indicate the end points of each layer. When the 590 Optical Monitor readout reaches these points, the operator terminates that layer deposition and advances to the next layer.

Proven Design and Reliability

The Dyn-Optics Model 590 Optical Monitor has been the workhorse of the optical coating industry for over 30 years. Based on a non-nonsense solid design, the 590 will give years of reliable service.

Full Support ??

Dyn-Optics has been providing optical monitors to the coating industry for over 30 years. Our engineers will guide you through the entire process from selecting the right optical monitor configuration to installation and set up.

• Precision Layer Termination
• 350-2500nm Wavelength Range
• Synchronous Detection
• 5 Decade Gain Control
• 10-Turn Variable Gain Adjustment
• Reflection or Transmission Modes
• Analog Output for Stripchart Recorder
• Zero Suppression
• Field-proven Design

• Monochrometer for continuous wavelength selection.
• RS-232 or USB Interface
• Fiber Optic Input / Outputs

This the details section of the 590 product file